|
|
|
The HR12A Palm Pad Remote Control sends Wireless Radio Frequency (RF) signals to an X-10 Transceiver
(RR501 or TM751) or any X-10 security system base receiver. The receiver then passes the signals onto
your house wiring to control lights or appliances around your home. You plug lights and appliances
into X-10 Modules (sold seperately). The Palm Pad also works with the CM11A Two-Way Computer Interface
to initiate macros (routines) so you can set up a "coming home" routine which is initiated when you
press a button on the Palm Pad.
- Install 4 AAA alkaline batteries (sold separately) in the Palm Pad's battery compartment.
- Use a dime to set the Housecode dial to match the X-10 Modules and Tranceiver you want to control.
- Plug in an X-10 Transceiver (RR501 or TM751, sold separately).
- Set the Palm Pad's slide switch to 1-8 to control X-10 Modules set to Unit Codes 1 thru 8.
- Set the slide switch to 9-16 to control X-10 Modules 9 thru 16.
- Press the corresponding ON or OFF button to turn X-10 Modules on and off.
- To brighten or dim lights connected to X-10 Lamp Modules and Wall Switch Modules, first press the corresponding number button, then press the UP or DOWN (blue) buttons.
|
|
DISCLAIMER:
These instructions are provided here as a convenience for those who have already purchased
the home automation module described, and may have lost or discarded their original instructions.
Under no circumstances does the owner of this web site attest to the accuracy or usefulness of
these instructions. Use them at your own risk.
|
|
