|
|
- Use a dime or a small screwdriver to set red Housecode dial on the Lamp Module to same leter as you set on the Controller.
- Set black Unit Code dial on the Lamp Module to a number between 1 and 16.
- Check that the lamp switch is in the ON position, unplug the lamp from its receptacle and plug it into the Lamp Module.
- Plug the Lamp Module into a standard 120 VAC wall outlet.
- The lamp will be ON or OFF at this time.
- Repeat steps above for any other lamps you wish to set up.
|
|
DISCLAIMER:
These instructions are provided here as a convenience for those who have already purchased
the home automation module described, and may have lost or discarded their original instructions.
Under no circumstances does the owner of this web site attest to the accuracy or usefulness of
these instructions. Use them at your own risk.
|
|
