|
The SS13A works with the RR501 (part of the RC5000) and the TM751 (part of the RC6500). It lets you turn on and off
three individually coded X10 Modules and brighten and dim lights connected to Lamp Modules and Wall Switch Modules.
In the default state (after first fitting the battery) the SS13A is set to Housecode A. The top three ON-OFF rocker
keys control modules set to Unit Codes 1, 2, 3. The bottom rocker key brightens and dims lights connected to Lamp
and Wall Switch Modules.
- Plug in an X10 Transceiver (RR501 or TM751, sold separately).
- To turn on or off X10 Modules set to Unit Codes 1,2 or 3 (on Housecode A) press the left or right side of the
first, second or third rocker key. To brighten or dim Lamp Modules or Wall Switch Modules press the number button
first, then press and hold the left or right side of the bottom rocker key. Attach the SS13A to a wall using double
sided tape or Velcro™. If you want to control Modules 1, 2 and 3 on Housecode A, that's it. You don't need to
read any further.
To Change the Housecode
- Press and hold the first (top) ON rocker key. The red LED flickers, 3 seconds later, the LED blinks the current setting: 1 blink for Housecode A, 2 blinks for B...16 blinks for P.
- Release the first (top) ON rocker key.
- Press and release the first (top) ON rocker key the appropriate number of times for the Housecode you want to set. Once for A, twice for B, etc. The LED blinks for each press. IMPORTANT: Hold the key on your last press. 3 seconds later, the red LED blinks back the new setting, e.g. 3 blinks for Housecode C. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed.
To Change the Unit Code
This procedure only changes the code for the first (top) rocker key. The second and third rockers are always one number higher than the first, i.e. if you set the first rocker key to 6, the second rocker key controls 7, and the third 8, etc.
- Press and hold the top OFF rocker key. The red LED flickers. 3 seconds later, the LED blinks the current setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16.
- Release the top OFF rocker key.
- Press and release the top OFF rocker key the appropriate number of times for the Unit Code you want to set.
IMPORTANT: Hold the key on your last press. 3 seconds later the red LED blinks back the new setting. If you do not follow this programming sequence, the LED will stay on for 1 second and your existing setting will not be changed.
To Change the Battery:
Open the battery holder and fit a CR2032 Lithium 3V batter. Observe polarity.
|
