|
|
- Use a small screwdriver to set the red Housecode dial on the Wall Switch Module to the same letter as you set on the Controller. Set the black Unit Code dial to a number between 1 and 16.
TURN OFF THE POWER AT THE CIRCUIT BREAKER OR FUSE.
- Remove existing wall switch plate, unscrew the old switch from the wall box, and disconnect the wires from it.
- Connect the wires on the Wall Switch Module (black and blue) to the same two wires that went to the old switch using the wire nuts provided. Make sure that the connections are tight and that there are no bare "whiskers" of wire which can touch the wall box.
- Screw the Wall Switch Module back into the wall box. Move the power ON/OFF slide switch to the ON position (in center). Re-fit the cover plate. Note: Move teh slide switch to the left (OFF) when changing a light bulb.
- Repeat steps above for any other wall switches you want to control.
|
|
DISCLAIMER:
These instructions are provided here as a convenience for those who have already purchased
the home automation module described, and may have lost or discarded their original instructions.
Under no circumstances does the owner of this web site attest to the accuracy or usefulness of
these instructions. Use them at your own risk.
|
|
